Real Huawei H12-811_V1.0 Exam Dumps with Correct 701 Questions and Answers [Q134-Q156]

NEW QUESTION 134
Switch stacking supports more than two devices, and multiple switches can be grouped into a logical device through stacking. ()

NEW QUESTION 135
A company applies for a Class C IP address segment, which needs to be evenly distributed to 8 subsidiaries.
The largest subsidiary has 14 computers. Different subsidiaries must be in different network segments, so the subnet mask should be set to.

NEW QUESTION 136
In the network shown in the figure below, the bridge ID of the switch has been marked. Enter the command stp rootsecondary on the sWD. switch and the following switch will become the root bridge of this network. ()

NEW QUESTION 137
DNS is used for domain name resolution

NEW QUESTION 138
What is the function of the command port trunk allow pass vlan all? ()

NEW QUESTION 139
When using the ping command on the VRp platform, if you need to specify a P address as the source address of the echo request message, which of the following parameters should be used? ()

NEW QUESTION 140
What are the advantages of using dynamic host configuration protocol DHCP to assign IP addresses? ()*

NEW QUESTION 141
The role of the OSPF protocol is

NEW QUESTION 142
UDP is oriented to connectionless and must rely on () to ensure the reliability of transmission. ()

NEW QUESTION 143
In order to implement FIT AP online, FIT AP first needs to obtain the IP address of AC. Which of the following options is not included in FITAP obtaining the IP address of AC. ()

NEW QUESTION 144
The network shown in the figure below. Host A is not configured with a gateway, and Host B has the ARP cache of the gateway. Which of the following statements are correct? () (Multiple Choice Question) The answer describes the address wrong

NEW QUESTION 145
Which of the following are not characteristics of a small campus network?

NEW QUESTION 146
In VRPOn the platform, the command”interfacevlanit<vlan-id>”The role is (). ()

NEW QUESTION 147
UDP cannot guarantee the reliability of data transmission, and does not provide functions such as message ordering and flow control. It is suitable for traffic with low transmission reliability requirements but high transmission speed and delay requirements.

NEW QUESTION 148
What kind of packets does the OSPF protocol use to send LSAs to neighbors? ()

NEW QUESTION 149
What is the default server port number used by the Telnet protocol?

NEW QUESTION 150
As shown in the figure, is the description of this network topology correct? () (Single-choice question)

NEW QUESTION 151
Which of the following parameters is not included in the configuration BPDU of the STP protocol? ()

NEW QUESTION 152
The NAT configuration is as follows, which IP can be converted when accessing the public network (RTA) acl2000 (RTA-acl-basic-2000) rule5 permit source 192.168.1.00.0.0.255 RTA-acl-basic-2000) rule 10 deny source 192.168. 1.30 (RTA-acl-basic-2000) quit RTA) interface serial1/0/0 (RTA-Serial1/0/0) nat outbounD.2000*

NEW QUESTION 153
The output information of the router R1 routing table is shown in the figure. Which of the following statements is correct? () (Multiple Choice Questions)
<R1>display ip routing-table
Route Flags: R-relay, D-download to fib

NEW QUESTION 154
As shown in the figure below, the MAC address table of SWA is as follows. The switch never learns the MAC address of host A.
Which of the following is impossible?

NEW QUESTION 155
In order to detect the connectivity status of the CAPWAP tunnel, after the CAPWAP tunnel is established, which of the following CAPTAP messages is used by the AC for detection? ()*

NEW QUESTION 156
The output information of the router is shown in the figure. Which of the following statements is wrong? () (Single-choice question)