300-425 Dumps 2022 New Cisco 300-425 Exam Questions [Q52-Q73]

4.3/5 - (9 votes)

300-425 Dumps 2022 – New Cisco 300-425 Exam Questions

Free 300-425 braindumps download (300-425 exam dumps Free Updated)

Conclusion

The Cisco 300-425 exam intends for you to master practical issues around wireless networks, and specifically those associated with the enterprise. Training and guidebooks are present to build your potential in this key sphere. So, anyone looking around for a beefing up of their skills in the sector should see to them that he or she takes and passes the actual test with ease.

NO.52 An engineer must speed up the reauthentication delays that are being experienced on the wireless infrastructure by deploying a key-caching mechanism. Which mechanism must be configured?

PEAP

PMF

GTK-randomization

NO.53 A customer called with a requirement that internal clients must be on different subnets depending on the building they are in All access points are operating in local mode and will not be modified, and this is a single controller solution Which design approach creates the desired result?

Create AP groups for each desired location, map the correct VLANs to the internal SSlD and add the access prints for that location

Create an SSID. place it to the desired VLAN under WLANs. and configure 802.ix in ISE to assign the correct VLAN based on the SSlD from which the client is authenticating.

Create FiexConnect groups, place the access points in. and set the correct VLAN to SSlD mapping based on location.

Create mobility anchors for the SSID. and on the controller under the internal SSID. create a foreign map to the desired VLAN based on location

NO.54 Which statement about creating a mobility group is true, excluding mobility anchors?

Each WLC must use the same mobility name and be defined as a peer in each other’s static mobility members list.

If WLCs with HA SSO are deployed, each WLC in the WLC HA pair considered separately as a mobility peer.

The WLCs do not have to be of the same model or type to be a member of a mobility group, however each member should be running different software versions.

A mobility groups does not require all WLCs in the group to use the same virtual IP address.

NO.55 A wireless engineer is designing a wireless network to support real-time applications over wireless. Which IEEE protocol must the engineer enables on the WLC so that the number of packets that are exchanged between an access point and client are reduced and fast roaming occurs?

802.11w

802.11r

802.11i

802.11k

NO.56 A network engineer is preparing for an office site survey with a height of 2.5 meters. Which three components are recommended to complete the survey? (Choose three.)

Use a battery pack to power APs

Use a drawing of the office space to draw AP and client placements.

Use DoS attack on APs while measuring the throughput.

Use APs with directional antennas.

Use APs with external antennas.

Use APs with built-in antennas.

NO.57 An engineer must configure the virtual IP address on multiple controllers in a mobility group. Which rule must the engineer follows to ensure proper roaming?

Ensure that the DNS entry is tied to the virtual IP address of the WLC.

Use a unique IP address for each WLC.

Ensure that the DNS Host Name field is defined.

Use the same IP address for each WLC.

NO.58 A customer called with a requirement that internal clients must be on different subnets depending on the building they are in. All access points are operating in local mode and will not be modified, and this is a single controller solution. Which design approach creates the desired result?

Create AP groups for each desired location, map the correct VLANs to the internal SSID, and add the access points for that location.

Create an SSID place it to the desired VLAN under WLANs and configure 802.1x in ISE to assign the correct VLAN based on the SSID from which the client is authenticating

Create FlexConnect groups, place the access points in, and set the correct VLAN to SSID mapping based on location.

Create mobility anchors for the SSID and on the controller under the internal SSID create a foreign map to the desired VLAN based on location.

NO.59 A technician connects a Cisco Aironet 3700 Series access point to a switch and realizes that the AP is coming up with 3×3 MIMO. Which reason explains this behavior?

A redundant power supply is unavailable on the switch.

The switch is 802.3af capable.

The AP is getting power from a power injector.

The switch is PoE+ capable.

NO.60 An engineer is performing a predictive wireless design for a medical treatment environment, which requires data and voice services. What is the minimum requirement for the design?

overlapping -72 dBm coverage from two access points

continuous -67 dBm coverage from one access point

continuous -72 dBm coverage from one access point

overlapping -67 dBm coverage from two access points

NO.61 An engineer is designing a wireless deployment for a university auditorium. Which two features can be used to help deal with the issues introduced by high AP count? (Choose two.)

TSPEC

RXSOP

TPC

LSS

DFS

NO.62 An engineer must perform a pre-deployment site survey for a new building in a high-security area. The design must provide a primary signal RSSI of -65 dBm for the clients. Which two requirements complete This design? (Choose two)

Site access

AP model

WLC model

HAVC access

Number of clients

NO.63 Which three pieces of equipment are needed to conduct a fully measured wireless survey? (Choose three.)

PoE battery

spirit level

access point

tall tripod

goggles

ladder

NO.64 A wireless network consultant must assess an existing wireless LAN controller. Which section must the consultant check before replacing the old APs with APs that are IEEE 802.11ac-capable?

number of AP licenses

controller PSU

throughput capacity

software version

NO.65 Which Cisco IOS VPN technology leverages Ipsec, mGRE, dynamic routing protocol, NHRP, and Cisco Express Forwarding?

FlexVPN

DMVPN

GETVPN

Cisco Easy VPN

NO.66 Drag and drop the characteristics from the left onto the correct functionalities on the right.

NO.67 An engineer has successfully configured high availability and SSO using two Cisco 5508 Wireless LAN Controllers. The engineer can access the Active Primary WLC, but the Secondary Standby WLC is not accessible. Which two methods allow access to the standby unit? (Choose two.)

via the console connection

SSH to the redundancy management interface of the primary WLC

SSH to the service port interface

SSH to the virtual interface of the secondary WLC

SSH to the management interface of the primary WLC

NO.68 A medium-sized hospitality company with 50 hotels needs to upgrade the existing WLAN m each hotel to 802Hn During the site surveys tor each hotel, what needs to be taken into consideration when determining the locations for each AP?

Selecting AP locations where power is already available

Selecting APs that can be hidden in ceiling panels lo provide a secure and clean aesthetic look.

Selecting locations that make visual assessment of the AP operation easy

Selecting locations that are easily accessed so maintenance and upgrades can be performed quickly

NO.69 An engineer is designing a wireless network to support high availability. The network will need to support the total number of APs and client SSO. Live services should continue to work without interruption during the failover Which two requirements need to be incorporated into the design to meet these needs? (Choose two.)

redundant WLC

controller high availability pair with one of the WLCs having a valid AP count license

10 sec RTT

back-to-back direct connection between WLCs

WLC 7.5 code or more recent

NO.70 Refer to the exhibit.

A client roams between two APs that are registered to two different controllers, where each controller has an interface in the client subnet. Both controllers are running AireOS. Which scenario explains the client roaming behavior?

Controllers exchange mobility control messages (over UDP port 16666) and the client database entry is moved from the original controller to the new controller.

Controllers do not exchange mobility control messages (over UDP port 16666) and the client database, entry is not moved from the original controller to the new controller.

Controllers exchange mobility control messages (over UDP port 16666) and a new client session is started with the new controller.

Controllers exchange mobility control messages (over UDP port 16666) and the client database entry is tunneled from the original controller to the new controller.

NO.71 Which two statements indicate a valid association mode for NTP synchronization? (Choose two.)

The client polls NTP servers for time.

The client broadcasts NTP requests.

The client listens to NTP broadcasts.

The client creates a VPN tunnel to an NTP server.

The client multicasts NTP requests.

NO.72 Where must the APs be mounted when used in a high-density wireless network to provide 6 dB to 20 dB of attenuation to a cell?

in the aisle

under the seat

above the stage

under the stage

NO.73 A wireless engineer is performing a post verification of a wireless network. Which two metrics does the engineer verify to ensure that the wireless network can support voice services? (Choose two.)

The coverage area must have a noise floor that does not exceed -87 dBm.

The client device must have at least an -67 dBm RSSI.

The rate of retransmitted packets must be 15 percent or below.

The rate of retransmitted packets must be 20 percent or below.

The client device must have at least an -65 dBm RSSI.

Those who are aiming to know more about designing Cisco enterprise wireless networks and want to validate their skills in this area, can take 300-425 ENWLSD test. It covers wireless and wired infrastructures, high availability, and other concepts crucial for networking professionals.

Verified 300-425 dumps Q&As – Pass Guarantee Exam Dumps Test Engine: https://www.dumpstorrent.com/300-425-exam-dumps-torrent.html

300-425 Dumps 2022 New Cisco 300-425 Exam Questions [Q52-Q73]

Conclusion

admin

Leave a Reply Cancel reply