[2023] H35-481_V2.0.pdf – Questions Answers PDF Sample Questions Reliable [Q19-Q38]

Q19. Which of the following scenario using the GUI configuration mode in MAE- Deployment?

Q20. Which of the following functions is provided by the network layer in the transport protocol stack?

Q21. 5G can enable smart manufacturing and upgrade the manufacturing business model. Which of the following are smart manufacturing scenarios empowered by 5G?

Q22. If the NRDUCELL corresponding to NRCELL Is not set up, the NRCELL must be unavailable.

Q23. Which of the following are possible causes of NRDUCELL unavailability?

Q24. If the subcarrier spacing (SCS) of a low-frequency cell Is 30 kHz and the bandwidth of each RB Is 360 kHz, theoretically, what value should the noise (dBm) over the air interface be?

Q25. Which of the following 5G technologies can be used to ensure the QoS and security of smart grid services?

Q26. When a GPS divider is used, the maximum distance between the GPS antenna and the BBU is shortened.

Q27. Which of the following boards do not support 5G?

Q28. Which of the following synchronization rasters can be used by a UE during a cell search?

Q29. In the contention-based random access procedure, which of the following is related to the time-frequency position of the PRACH used by the UE?

Q30. Which of the following commands is used to map DSCPs and VLAN priorities?

Q31. What Is the maximum number of pRRUs on a CPRI link for RF combination?

Q32. Which of the following slots retains the same physical position on both the BBU5900 and BBU3910?

Q33. If multiple IP addresses with different next hop addresses are planned for the gNodeB, which of the following route configuration modes is not applicable?

Q34. Which of the following actions will trigger SgNB release by the MeNB?

Q35. In NSA networking, which of the following objects are unnecessary to configrued for a gNodeB in SI self-setup scenarios?

Q36. Which of the following channels is not involved in NR random access of a UE?

Q37. In CRAN deployment, the one-to-four cascading mode can be used for GPS clock configuration. How many BBUs at most can a GPS be connected to?

Q38. If the configuration data of a new BTS5900 base station cannot be loaded remotely, which of the following can be used to for local data configuration?