Ultimate Guide to Prepare H35-480_V3.0 Certification Exam for HCIA-5G in 2023 [Q20-Q39]

NEW QUESTION 20
Which of the following actions are involved in NAS procedure management in 5G?

NEW QUESTION 21
During 5G single site verification, you only need to test the user access and rate. Other test items are analyzed in drive tests.

NEW QUESTION 22
Which of the following is the correct sequence for adding gNodeB hardware?

NEW QUESTION 23
Which type of information about NR cells is carried in the neighboring NR cell MRs reported by UEs?

NEW QUESTION 24
In NSA networking, which of the following commands can be used to check whether the Sl-U interface is normal?

NEW QUESTION 25
An NR CQI value represents a coding scheme and coding efficiency. How many bits does a CQI value reported by a UE have?

NEW QUESTION 26
What is the maximum MIMO mode supported by Huawei 5G indoor CPE?

NEW QUESTION 27
Which of the following is the correct sequence for adding gNodeB hardware?

NEW QUESTION 28
5G inherits the frame structure of 4G, but the slot length can be adjusted based on different SCSs. Which of the following is not a 5G slot length?

NEW QUESTION 29
F-OFDM over the NR air interface uses flexible subcarrier spacing to meet the requirements of different 5G service scenarios. Which of the following types of subcarrier spacing is not supported by Sub6G?

NEW QUESTION 30
A larger CQI value indicates a better channel quality.

NEW QUESTION 31
On an NSA network, the eNodeB immediately triggers the SgNB addition procedure after a UE attaches to the LTE network. If the SgNB addition fails, the eNodeB attempts to add the SgNB again until it is successful.

NEW QUESTION 32
The BBU5900 uses a modular design. Which of the following subsystems constitute the BBU? (Choose All that Apply)

NEW QUESTION 33
Which of the following channels (signals) can be used for cell measurement in NR?

NEW QUESTION 34
Which of the following messages is the first message sent by a gNodeB to an AMF?

NEW QUESTION 35
The RSRP value of the test terminal can be viewed on the GENEX Probe. Which of the following test results indicate good signal quality?

NEW QUESTION 36
If multiple IP addresses are planned for a gNodeB and the next-hop IP addresses are different, which of the following route configurations is more suitable?

NEW QUESTION 37
During single site verification, which of the following messages can be traced by the Probe to analyze problems?

NEW QUESTION 38
What is the required distance between a CPE and a gNodeB in a 5G network test?

NEW QUESTION 39
Which of the following MML commands is used to bind a physical sector to an AAU on a gNodeB?