[Oct 14, 2023] Achive your Success with Latest NACE NACE-CIP1-001 Exam [Q51-Q70]

NO.51 Common errors that can produce inaccurate readings when using Wet Film Thickness (WFT) gauges include:
Select All That Apply

NO.52 Inspector’s daily reports are used:
Select All That Apply

NO.53 Passivation can best be described as:

NO.54 The Inspector should record the serial numbers of inspection instruments:

NO.55 NACE No. 4/SSPC-SP-7 is a joint standard for

NO.56 What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) area?

NO.57 You are an inspector on a project where SSPC SP 3 is specified.
What sort of tools should you expect the Contractor to use to achieve the standard?

NO.58 In the event of a conflict between the project specification and the coating manufactures’ product data sheet, the Inspector’s first course of action should be too:

NO.59 If the project specification DOES NOT state the specific DFT measurement standards, the inspector should use

NO.60 A magnetic pull-off type gauge is a good choice when:

NO.61 You ate the NACE Inspector on a job where NACE No. 2/SSPC – SP 10 has been specified. You are finding the Contractor is leaving mill scale on the on surface and as a result you have been rejecting the blast. The Contractor is very upset and has told you that the standard permits up to 5% of the mill scale to remain and still be in be in compliance with the standard.
Your FIRST preferred course of action is to:

NO.62 A single application coating film has a measured dry film thickness (DFT) between 4 and 5 mils (between 100 and 125 microns). The volume solids of the coating immediately before application were 67%, What wet film thickness (WFT) was applied?

NO.63 What is used to determine compressed air cleanliness?

NO.64 Which of these tests uses a syringe?

NO.65 Stripe coats are generally applied to:

NO.66 ISO ST 3 is described as:

NO.67 You are asked to be the only coating inspector on a small bridge recoating job where existing coating contains lead. The owners’ representative has supplied you with the local code governing the removal and disposal of lead based coatings, however upon reading the document you having great deal of difficulty understanding the technical language.
As a NACE CIP Level 1 Inspector your preferred course of action is to:

NO.68 How many gauge readings does SSPC-PA 2 require within a 4 cm (1.5 inch) diameter circle?

NO.69 When holiday testing is required the Inspector is always required to enforce NACE SP 0188:

NO.70 As a NACE Coating Inspector your responsibility with respect to safety is to: