[Q32-Q50] 2023 Reliable Study Materials & Testing Engine for NACE-CIP2-001 Exam Success!

QUESTION 32
All of these are advantages of using repair patches EXCEPT

QUESTION 33
The main reason dehumidification is used during coating operations is to

QUESTION 34
External coatings applied to buried pipelines are generally tested for:

QUESTION 35
As a NACE Level 2 Inspector, NACE clearly indicates that you ate qualified to independently produce final documentation for a shop project.

QUESTION 36
A failure caused by applying a coating too thinly is known as

QUESTION 37
The HATE adhesion tester uses

QUESTION 38
You are a NACE Level 2 Coating Inspector who has just arrived on a job in progress where there is no Inspection and Test Plan (ITP). The first morning you arrive the job is behind schedule and you are asked to take DIY Film Thickness readings.
Your FIRST preferred course of action is to:

QUESTION 39
Differences in technique for abrasive blasting concrete versus steel require the operator to:

QUESTION 40
When NACE/SSPC WJ 1 is referenced; what type of equipment would the Inspector expect to see on the job:

QUESTION 41
When using a destructive Paint Inspection Gauge the NACE inspector must:

QUESTION 42
You are working as the only in-house NACE Level 2 Inspector in a shop setting when an independent 3 rd party NACE Level 3 Inspector, representing the owner, presents you with a copy of a Non Conformance Report (NCR) he has written for a NACE2/SSPC SP 10 centrifugal blast which you had previously approved.
Your FIRST preferred course of action is to:

QUESTION 43
The Concrete Repair Institute’s comparators can be used to assess:

QUESTION 44
Which type of pipelines collect the gas from the transmission system so utility companies can distribute the gas to end users?

QUESTION 45
The primary purpose of Fireproofing coatings are to provide:

QUESTION 46
You are NACE Level 2 Inspector working on a tank lining job where a mobile centrifugal blast unit is being used to blast the tank floor to a NACE No.1/SSPC SP 5. The Contractor has completed his final blast and has called for a hold point inspection. This is the 1 st time you have seen field based centrifugal blast cleaning. You observe what appears to be staining on the substrate however the Contractor assures you this is normal when using centrifugal blast units and what you are seeing is what is defined in the standard as an acceptable variation in appearance.
Your FIRST preferred course of action is to:

QUESTION 47
In the event of a conflict between the Product Data Sheet and the Specification:

QUESTION 48
Which surface preparation method uses a dilute acid solution to remove laitance and I roughen the concrete surface?

QUESTION 49
Dehumidification is defined as the removal of moisture vapor from the air to

QUESTION 50
Which product, when closely inspected has a green or red layer of fusion bonded epoxy (FBE) that is visible directly on the steel?