Verified H35-480_V3.0 dumps Q&As 100% Pass in First Attempt Guaranteed Updated Dump from DumpsTorrent [Q28-Q49]

Rate this post

Verified H35-480_V3.0 dumps Q&As 100% Pass in First Attempt Guaranteed Updated Dump from DumpsTorrent

Pass HCIA-5G H35-480_V3.0 Exam With 60 Questions

The Huawei H35-480_V3.0 exam is designed for professionals who are involved in the deployment of 5G RAN networks, including network engineers, system integrators, and network planners. The exam is also suitable for those who are interested in learning about 5G RAN technology and want to enhance their skills and knowledge in this area.

NO.28 During a 5G test, a portable computer is directly connected to the LAN port of the Huawei CPE through a network cable to obtain a dynamic IP address for communication.

True

False

NO.29 At which layer is downlink data split implemented over the NR air interface in the NSA Option 3x architecture?

RLC layer

MAC layer

PDCP layer

Physical layer

NO.30 Which of the following files must be prepared when remotely commissioning a gNodeB using the MAE Deployment? (Choose All that Apply)

Site deployment list

Data configuration file of the base station

Base station software package of the target version

Base station license

NO.31 Which of the following signals is measured by a 5G UE to report channel quality information such as the CQI, RI, and PMI to a gNodeB?

SSB SINR

CSI-RS SINR

SSB RSRP

CSI-RS RSRP

NO.32 According to 5G eMBB service requirements, which of the following is the minimum rate required for network edge coverage?

1 Gbps

100Mbps

1Mbps

10Gbps

NO.33 gNodeBs periodically send TPC commands to UEs over PDCCHs to control the transmit power of which of the following uplink channels or signals of UEs?

SRS

PUSCH

PUCCH

NO.34 During a 5G service test, an NSA UE connects to the Probe and then accesses a 4G cell. It is found that the cell does not deliver B1 measurement configurations. Which of the following is not a possible cause for this?

The UE does not support EN-DC.

The NSA switch is not turned on.

Neighboring LTE cells and SCGs are not configured.

The B1 threshold is too high.

NO.35 Which of the following actions are involved in NAS procedure management in 5G?

Registration management

RRC reestablishment

Session management

RRC connection setup

NO.36 During 5G single site verification, you only need to test the user access and rate. Other test items are analyzed in drive tests.

True

False

NO.37 Which of the following factors trigger measurement in connected mode in SA networking?

Periodic TAU

Whether or not the UE is moving

Whether or not neighboring frequencies are configured

Signal quality of the serving cell

NO.38 At which layer is downlink data split implemented over the NR air interface in the NSA Option 3x architecture?

RLC layer

MAC layer

PDCP layer

Physical layer

NO.39 Which of the following can be used to check whether an antenna is reversely connected during NR single site verification?

Fixed-point CQT

DT around the site

Transmission test

VSWR test

NO.40 Which of the following statements about the functions of an AAU are correct? (Choose All that Apply)

Up/down conversion of spectrum

Power amplification

Signal filtering

Baseband data processing

Analog-to-digital/digital-to-analog conversion

NO.41 Which of the following methods can be used by a gNodeB to obtain downlink channel characteristics?

DMRS of the uplink PUSCH of the UE

Downlink DMRS signal

UE-reported uplink PMI

Uplink SRS signal

NO.42 Which of the following statements about the NR slot structure are correct?

Downlink slots can only be used to transmit downlink data.

Downlink self-contained slots can be used to transmit uplink data and SRSs.

The number of symbols in one slot is fixed to 14 regardless of the subcarrier spacing configuration.

The symbols in a slot can be classified as downlink, uplink, or flexible.

NO.43 5G wireless network cloudification can significantly improve the user rate.

True

False

NO.44 SSB GSCN is the center frequency number of an NR cell.

True

False

NO.45 The BBU5900 uses a modular design. Which of the following subsystems constitute the BBU? (Choose All that Apply)

Main control subsystem

Transmission subsystem

Baseband subsystem

RF subsystem

NO.46 The mmWave range is new for NR. It supports the largest bandwidth in a cell but has poor coverage capabilities. It requires high performance from RF components and generally applies only to line of sight (LOS) coverage.

True

False

The mmWave range is a new spectrum range for 5G NR, and it supports the largest bandwidth in a cell. However, it has poor coverage capabilities, as it requires high performance from RF components and generally applies only to line of sight (LOS) coverage. This makes it challenging to use in many applications, as it requires careful planning and implementation in order to ensure effective coverage.
https://www.gsma.com/futurenetworks/wiki/5g-implementation-guidelines/
5G Implementation Guidelines: NSA Option 3 – Future Networks
https://www.gsma.com/futurenetworks/wiki/5g-implementation-guidelines/
https://www.ericsson.com/en/ran
5G RAN – Radio Access Networks – Ericsson
https://www.ericsson.com/en/ran
https://www.5gamericas.org/wp-content/uploads/2020/12/InDesign-Understanding-mmWave-for-5G-Networks.pdf Understanding mmWave for 5G Networks 1 – 5G Americas
https://www.5gamericas.org/wp-content/uploads/2020/12/InDesign-Understanding-mmWave-for-5G-Networks.pdf The millimeter wave (mmWave) range is new for 5G NR (New Radio). It supports the largest bandwidth in a cell but has poor coverage capabilities. It requires high performance from RF components and generally applies only to line of sight (LOS) coverage.
The mmWave range is considered to be the higher frequency range of the 5G spectrum and it includes frequencies above 24GHz, such as 28GHz, 38GHz and 60GHz. These frequencies offer a large amount of bandwidth, which is necessary to support high-data rate services, such as ultra-high-definition video streaming, virtual reality, and the internet of things.
However, the mmWave range has poor coverage capabilities because the signals are easily blocked by obstacles such as buildings and trees, and they also have a shorter propagation distance than lower frequency bands. Therefore, mmWave range is generally used for high-density urban areas, and indoor environments.
Additionally, RF components for mmWave have to meet high performance requirements, such as high linearity, high gain and high power handling capability. Also, the mmWave signals are highly sensitive to the presence or absence of a clear line of sight (LOS) between the transmitter and the receiver, which makes it less reliable for non-line-of-sight (NLOS) coverage.

NO.47 In SA networking, the mobile country code (MCC) and mobile network code (MNC) information added on the gNodeB must be consistent with the PLMN information on the core network.

True

False

NO.48 What are the typical sizes of ping packets and intervals in single site verification?

1500bytes, 2s

1500 bytes,1s

32 bytes,1s

32 bytes, 2s

NO.49 The RSRP value of the test terminal can be viewed on the GENEX Probe. Which of the following test results indicate good signal quality?

30 to 60dBm

-60dBm to -90dBm

0 to 60dBm

-30 to -60dBm

The HCIA-5G-RAN V3.0 exam is a valuable certification for individuals who are looking to advance their career in the telecommunication industry. This certification provides individuals with the necessary knowledge and skills to work with Huawei’s 5G RAN technologies and to deploy, configure, and troubleshoot 5G RAN networks. The certification is also recognized by organizations worldwide, making it a valuable addition to any professional’s resume.

Pass H35-480_V3.0 Tests Engine pdf – All Free Dumps: https://www.dumpstorrent.com/H35-480_V3.0-exam-dumps-torrent.html

Verified H35-480_V3.0 dumps Q&As 100% Pass in First Attempt Guaranteed Updated Dump from DumpsTorrent [Q28-Q49]

admin

Leave a Reply Cancel reply