API New 2023 API-570 Sample Questions Reliable API-570 Test Engine [Q61-Q81]

QUESTION 61
When an entire piping assembly is to be heat treated, but it will not fit into the furnace, what action should be taken?

QUESTION 62
Radiographic profile techniques are preferred over ultrasonic thickness measuring instruments for pipe diameters of:

QUESTION 63
all suspect areas and areas of damaged insulation should be examined?

QUESTION 64
What is the working pressure of a 150 Ib. flange, SA 350 Gr.LF6 CL 1, used at 400°F?

QUESTION 65
A specialized valve generally used in erosive or high-temperature service is a valve

QUESTION 66
Austenitic stainless steel piping systems operating between 150°F-400°F are susceptible to:

QUESTION 67
Which of the following methods can be used to join cast iron pipe?

QUESTION 68
What is the required thickness of straight run pipe subject to internal pressure only, based on the following conditions: NPS 14, SA 285 Gr.C, EFW Spiral seam (No radiography), operating at 216 psi / 378?F

QUESTION 69
According to API 570, a(n) is a person who assists the inspector by performing specific NDE testing.

QUESTION 70
Penetrameters are normally placed on the side of the part being examined.

QUESTION 71
The radiograph of a Normal Fluid service piping weld revealed a crack.
What is the acceptable crack length if the pipe wall was 0.375?

QUESTION 72
What is the maximum length allowed for individual slag trapped in a weld in a Severe Cyclic Conditions piping system?

QUESTION 73
A leak test was performed on a buried piping system. The system was re pressured to 125 psi four hours into the test. Sometime during the final four hours, the gauge fell 5

QUESTION 74
Hammer testing of piping is a common practice. However, which of the following should never be hammered?

QUESTION 75
The repair organization shall maintain records of welding procedures and welder qualifications and make the records available to the inspector_____.

QUESTION 76
The repair organization shall use welders and welding operators qualified in accordance with the code to which the piping was built or alternatively_____.

QUESTION 77
What is the inspection interval for buried piping without cathodic protection, the soil resistivity is 6,500 ohm-cm?

QUESTION 78
Given the above information, what is the short term corrosion rate of the above piping system?

QUESTION 79
Give the corresponding “P” number for SA 414 Gr.A material

QUESTION 80
Each piece of magnetizing equipment shall be calibrated

QUESTION 81
All piping system repair and alteration welding shall be done in accordance with: